INSTALLATION AND HARDWARE VISIBILITY
The back of the plank is laminated with an acoustically transparent black matt, which hides any potential insulation or hardware color read through. Note: In specific lighting conditions, it may be necessary to paint the hardware (wood blocking or steel furring channels) matte black at the plank joint locations.

WARRANTY
Solo has the same warranty period as other Decoustics products. Close attention must be paid to acclimatization, and to finished room conditions. Wood products are highly susceptible to changes in humidity and temperature. Where a schedule dictates that the product is installed prior to the establishment of temperature and humidity controls at the site, the warranty will be void.
SOLO PLANKS MUST BE STORED, INSTALLED AND MAINTAINED ONLY IN A SECURE AMBIENT ENVIRONMENT (HUMIDITY MIN. 35% - MAX. 55%,TEMPERATURE NOT TO EXCEED 27°C/80°F).
Solo planks must be allowed to stabilize on site for 72 hours prior to installation.

Note: The information provided in this installation guide is accurate to the best of our knowledge at the time of printing. However, we reserve the right to make changes when necessary without further notification. Suggested applications may need to be modified to conform with local building codes and conditions. We cannot accept responsibiltiy for products that are not used, or installed to our specifications.
6. With holes aligned tap each successive plank tongue into previously installed board groove. Check each plank is level and plumb, and secure groove edge (blind nail/screw into blocking, or Solo clip and framing screw into steel furring channel). 7. If necessary trim finisher plank to correct width. The tongue of the finisher plank is inserted into the groove of the previous plank, and then secured with finishing nails at a groove location into the vertical wood blocking.
8. Where coverage area exceeds plank length, gap end-to-end planks with 2mm (5/64”) shim as shown.
9. Finish perimeter of wall or ceiling Solo installation with suitable trims or moldings as desired.