STANDARDS, TESTS, AND APPROVALS
Surface Burning Characteristics (ASTM E-84): All panel components have a Flame Spread rating of less than 25.
Note: Building code requirements may necessitate composite panel testing based on specified finish. A panel comprised of "Class A" (Flame Spread of 25 or less) components does not necessarily produce a composite panel meeting the "Class A" requirement. Decoustics has a considerable number of composite panel tests on file.
Acoustical Data (ASTM C423, Type A Mounting per ASTM E795): Panels were tested with 3/16" (5 mm) clip mounting.
FINISH PANEL THICKNESS FREQUENCY (Hz) NRC SAA
125 250 500 1000 2000 4000
Fabric
5/8" (16 mm) 0.01 0.25 0.67 0.98 1.01 0.96 0.75 0.71
Fabric
1-1/8" (28 mm) 0.17 0.60 1.02 1.08 0.93 0.82 0.90 0.89
Fabric
1-5/8" (41 mm) 0.42 0.72 1.10 1.11 0.98 0.92 1.00 .
Fabric
2-1/8" (54 mm) 0.54 0.87 1.03 1.14 0.94 0.91 1.00 0.98

Note: The information provided in this Data Sheet is accurate to the best of our knowledge at the time of printing. However, we reserve the right to make changes when necessary without further notification. Suggested applications may need to be modified to conform with local building codes and conditions. We cannot accept responsibility for products that are not used, or installed, to our specifications.

Note: Only handle panels wearing clean, lightweight, white gloves during installation.Follow manufacturer's printed instructions for installation as well as field cutting of panels.

...
FINISH EDGE OPTIONS PANEL SIZES
CONSTRUCTION
THICKNESS
NRC
 WEIGHT

Fabric or
Vinyl
Resin: square edge.

Concealed Extruded Aluminum: square edge *(butt and defined).

*butt for 1-1/8" & 2-1/8" thickness only defined for 1-1/8", 1-5/8" & 2-1/8" thickness only
Fabric or vinyl: Up to 60" x 120" (1525 mm x 3050 mm).

Finish width must be sufficient to cover panel, panel thickness, and wrap minimum 1" (25 mm) on back side.
Panel consists of a 6 to 7 pcf (96 to 112 kg/m3) core with a 1/8" (3 mm) thickness 16 to 20 pcf (256 to 320 kg/m3) high density appliqué facer. Panels and facers can be finished with fabric or vinyl and coatings e.g. Claro & Metallo. Fabric corners are fully tailored (no exposed darting) and vinyl corners are heat sealed.
5/8"
(16 mm)

7/8"
(22 mm)

1-1/8"
(28 mm)

1-5/8"
(41 mm)

2-1/8"
(54 mm)
0.75


0.80


0.90


1.00


1.00
0.90 psf (4.50 kg/m2)

1.0 psf
(4.90 kg/m2)

1.2 psf
(5.86 kg/m2)

1.45 psf (7.10 kg/m2)

1.75 psf (8.55 kg/m2)